Cisco MWR 2941 Installation Manual Page 308

  • Download
  • Add to my manuals
  • Print
  • Page
    / 710
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 307
-308
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
police (policy map)
Command Default No policing is performed.
Command Modes Policy-map class configuration (config-pmap-c)
Command History
burst (Optional) The token-bucket size in milliseconds (ms) for handling a
burst. Valid range is from 1 to 2000.
ms Milliseconds. When bandwidth is specified as a percentage, this keyword
must follow the burst argument.
flow Specifies a microflow policer that will police each flow.
mask Specifies the flow mask to be used for policing.
dest-only Specifies the destination-only flow mask.
full-flow Specifies the full-flow mask.
src-only Specifies the source-only flow mask.
Release Modification
12.2(14)SX This command was introduced on the Supervisor Engine 720.
12.2(17d)SXB This command was implemented on the Supervisor Engine 2 and integrated into
Cisco IOS Release 12.2(17d)SXB.
12.2(17d)SXB3 The police bps minimum rate was lowered from 32,000 to 8,000 on FlexWAN
interfaces only.
12.2(18)SXD This command was changed as follows:
Added set-mpls-exp-topmost-transmit to the valid values for the
conform-action keyword.
Changed the set-mpls-exp-transmit keyword to
set-mpls-exp-imposition-transmit.
12.2(18)SXE The bps maximum rate was increased from 4,000,000,000 to 10,000,000,000 bps
to support 10-Gigabit Ethernet.
12.2(18)SXF The CIR maximum rate was increased to 10,000,000,000 bps.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(31)SB The command behavior was changed so that if you modify only the police rate
parameters and not the police actions, the police actions default to the default
actions: conform-action transmit, exceed-action drop, and violate-action drop.
This was implemented on the Cisco 10000 series router for the PRE3.
12.2(33)SB The command behavior was changed so that if you modify only the police rate
parameters and not the police actions, the police actions are preserved. This was
implemented on the Cisco 10000 series router for the PRE3 and PRE4. For more
information, see the “Usage Guidelines” section.
12.2(33)SXH2 The CIR maximum rate was increased to 64,000,000,000 bps.
12.2(33)SXI The minimum CIR token bucket size was reduced to 1 byte.
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Page view 307
1 ... 307 308 309 ... 710

Comments to this Manuals

No comments