Cisco MWR 2941 Installation Manual Page 122

  • Download
  • Add to my manuals
  • Print
  • Page
    / 710
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 121
-122
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
ethernet cfm mep domain mpid
ethernet cfm mep domain mpid
To set a port as internal to a maintenance domain and define it as a maintenance endpoint (MEP), use
the ethernet cfm mep domain mpid command in interface configuration mode. Also, use this command
to place the command-line interface (CLI) in Ethernet connectivity fault management (CFM) MEP
configuration mode (config-if-ecfm-mep). To restore the default configuration of the port, use the no
form of this command.
ethernet cfm mep domain domain-name mpid mpid {port | vlan vlan-id}
no ethernet cfm mep domain domain-name mpid mpid {port | vlan vlan-id}
Syntax Description
Command Default This command is disabled.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines A single interface may belong to multiple domains, meaning that you can issue multiple instances of the
ethernet cfm mep domain mpid command for different domains.
If a specified domain has not been configured, an error message is displayed and the command is
rejected.
If an interface is manually provisioned to have a maintenance intermediate point (MIP) at a certain
maintenance level and you attempt to configure it as a MEP for a VLAN on the same or a higher level,
an error message is displayed and the command is rejected.
If the VLAN for which a MEP is configured is removed from an interface, the MEP configuration is also
removed; the VLAN and the definition of the MEP are interrelated.
domain-name String of a maximum of 154 characters.
mpid Integer from 1 to 8191 that identifies the MEP.
port Configures the DOWN service direction with no VLAN association
(untagged).
vlan Configures a VLAN.
vlan-id Integer from 1 to 4094 that identifies a VLAN.
Release Modification
12.2(33)SXI2 This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR. This
release does not support the level, inward, and outward keywords used to
configure CFM Draft 1.0.
Page view 121
1 ... 121 122 123 ... 710

Comments to this Manuals

No comments