Cisco MWR 2941 Installation Manual Page 428

  • Download
  • Add to my manuals
  • Print
  • Page
    / 710
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 427
-428
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
set ip dscp tunnel
set ip dscp tunnel
To set the differentiated services code point (DSCP) value in the tunnel header of a Layer 2 Tunnel
Protocol Version 3 (L2TPv3) or Generic Routing Encapsulation (GRE) tunneled packet for tunnel
marking, use the set ip dscp tunnel command in policy-map class configuration mode. To disable this
functionality, use the no form of this command.
set ip dscp tunnel dscp-value
no set ip dscp tunnel dscp-value
Syntax Description
Command Default The DSCP value is not set.
Command Modes Policy-map class configuration (config-pmap-c)
Command History
Usage Guidelines It is possible to configure L2TPv3 (or GRE) tunnel marking and the ip tos command at the same time.
However, Modular Quality of Service (QoS) Command-Line Interface (CLI) (MQC) (L2TPv3 or GRE)
tunnel marking has higher priority over ip tos commands, meaning that tunnel marking always rewrites
the IP header of the tunnel packet and overwrites the values set by ip tos commands. The order of
enforcement is as follows when these commands are used simultaneously:
1. set ip dscp tunnel or set ip precedence tunnel (L2TPv3 or GRE tunnel marking)
dscp-value Number from 0 to 63 that identifies the tunnel header value. The following
reserved keywords can be specified instead of numeric values:
EF (expedited forwarding)
AF11 (assured forwarding class AF11)
Release Modification
12.0(28)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRC This command was integrated into Cisco IOS Release 12.2(33)SRC.
12.4(15)T2 This command was integrated into Cisco IOS Release 12.4(15)T2, and
support for marking GRE-tunneled packets was included.
Note For this release, marking GRE-tunneled packets is supported only on
platforms equipped with a Cisco MGX Route Processor Module
(RPM-XF).
12.2(33)SB Support for marking GRE-tunneled packets was included, and support for
the Cisco 7300 series router was added.
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Page view 427
1 ... 427 428 429 ... 710

Comments to this Manuals

No comments