Cisco MWR 2941 Installation Manual download pdf (Page 37)

100

101

-37

Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR

OL-26895-01

Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR

class-map type traffic

To create or modify a traffic class map, which is used for matching packets to a specified Intelligent

Services Gateway (ISG) traffic class, use the class-map type traffic command in global configuration

mode. To remove a traffic class map, use the no form of this command.

class-map type traffic match-any class-map-name

no class-map type traffic match-any class-map-name

Syntax Description

Command Default A traffic class map is not created.

Command Modes Global configuration

Command History

Usage Guidelines Use the class-map type traffic command to specify the name of the ISG traffic class for which you want

to create or modify traffic class map match criteria. Use of the class-map type traffic command enables

traffic class-map configuration mode, in which you can enter match commands to configure the match

criteria for this class. Packets are checked against the match criteria configured for a class map to

determine if the packet belongs to that traffic class.

ISG traffic classes allow subscriber session traffic to be subclassified so that ISG features can be applied

to constituent flows. Traffic policies, which define the handling of data packets, contain a traffic class

and one or more features.

Once a traffic class map has been defined, use the class type traffic command to associate the traffic

class map with a service policy map. A service can contain one traffic class, and the default class.

Examples The following example shows the configuration of a traffic class map called “CLASS-ACL-101”. The

class map is defined so that input traffic matching access list 101 will match the class. The traffic class

map is then referenced in service policy map “mp3”.

class-map type traffic CLASS-ACL-101

match access-group input 101

match-any Indicates that packets must meet one of the match criteria in order to be

considered a member of the class.

class-map-name Name of the class map.

Release Modification

12.2(28)SB This command was introduced.

12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.

12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.

15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.

15.1(3)MR This command was integrated into Cisco IOS Release 15.1(3)MR.

1 ... 36 37 38 ... 710

Comments to this Manuals

No comments

Cisco MWR 2941 Installation Manual Page 37

Comments to this Manuals

Related products and manuals for Networking Cisco MWR 2941