Cisco MWR 2941 Installation Manual Page 400

  • Download
  • Add to my manuals
  • Print
  • Page
    / 710
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 399
-400
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
service-policy
service-policy
To attach a policy map to an input interface, a virtual circuit (VC), an output interface, or a VC that will
be used as the service policy for the interface or VC, use the service-policy command in the appropriate
configuration mode. To remove a service policy from an input or output interface or from an input or
output VC, use the no form of this command.
service-policy {input | output} policy-map-name
no service-policy {input | output} policy-map-name
Syntax Description
Command Default No service policy is specified.
A control policy is not applied to a context.
No policy map is attached.
Command Modes ATM bundle-VC configuration (config-atm-bundle)
ATM PVP configuration (config-if-atm-l2trans-pvp)
ATM VC mode (config-if-atm-vc)
Global configuration (config)
Interface configuration (config-if)
Map-class configuration (config-map-class)
PVC-in-range configuration (cfg-if-atm-range-pvc)
PVC range subinterface configuration (config-subif)
Command History
input Attaches the specified policy map to the input interface or input VC.
output Attaches the specified policy map to the output interface or output VC.
policy-map-name The name of a service policy map (created using the policy-map command)
to be attached. The name can be a maximum of 40 alphanumeric characters.
Release Modification
12.0(5)T This command was introduced.
12.0(5)XE This command was integrated into Cisco IOS Release 12.0(5)XE.
12.0(7)S This command was integrated into Cisco IOS Release 12.0(7)S.
12.0(17)SL This command was implemented on the Cisco 10000 series routers.
12.1(1)E This command was integrated into Cisco IOS Release 12.1(1)E.
12.1(2)T This command was modified to enable low latency queueing (LLQ) on
Frame Relay VCs.
12.2(14)SX Support for this command was implemented on Cisco 7600 series routers.
This command was changed to support output policy maps.
12.2(15)BX This command was implemented on the ESR-PRE2.
12.2(17d)SXB This command was implemented on the Supervisor Engine 2 and integrated
into Cisco IOS Release 12.2(17d)SXB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
Page view 399
1 ... 399 400 401 ... 710

Comments to this Manuals

No comments