Cisco MWR 2941 Installation Manual Page 154

  • Download
  • Add to my manuals
  • Print
  • Page
    / 710
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 153
-154
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
ethernet oam link-monitor supported
ethernet oam link-monitor supported
To enable support for link monitoring on an Ethernet operations, maintenance, and administration
(OAM) interface, use the ethernet oam link-monitor supported command in interface configuration
mode. To disable link monitoring support, use the no form of this command.
ethernet oam link-monitor supported
no ethernet oam link-monitor supported
Syntax Description This command has no arguments or keywords.
Command Default Link monitoring is supported when Ethernet OAM is enabled.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines Use this command to help establish an OAM session for performing OAM functions, such as remote
loopback. For example, if your device is connected to a third-party device that does not support link
monitoring, you must disable link monitoring support on your device to establish an OAM session with
the third-party device.
When the ethernet oam link-monitor supported command has been issued, remote loopback will not
function, whether or not an interface has been configured to support it.
The ethernet oam link-monitor supported command is enabled by default when Ethernet OAM is
enabled and does not display in the configuration when the show running-config command is issued.
When support for link monitoring is enabled by default, to turn it off you must explicitly disable it by
issuing the no form of this command.
Examples The following example shows how to disable support for link monitoring on the GigabitEthernet 0/1
OAM interface:
Router(config)# interface gigabitethernet 0/1
Router(config-if)# no ethernet oam link-monitor supported
The following example shows how to reenable support for link monitoring on the GigabitEthernet 0/1
OAM interface after support has been disabled:
Release Modification
12.2(33)SRA This command was introduced.
12.4(15)T This command was integrated into Cisco IOS Release 12.4(15)T.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Page view 153
1 ... 153 154 155 ... 710

Comments to this Manuals

No comments