Cisco MWR 2941 Installation Manual Page 319

  • Download
  • Add to my manuals
  • Print
  • Page
    / 710
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 318
-319
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
police rate (control-plane)
Command Default Disabled
Command Modes QoS policy-map class configuration
Command History
Usage Guidelines Use the police rate command to limit traffic that is destined for the control plane on the basis of packets
per second (pps), bytes per seconds (bps), or a percentage of interface bandwidth.
If the police rate command is issued, but the a rate is not specified, traffic that is destined for the control
plane will be policed on the basis of bps.
Table 1-6 lists the actions you can specify for the action argument.
peak-burst ms ms (Optional) Specifies the peak burst rate, in milliseconds, will be used for
policing traffic. Valid range is from 1 to 2000.
conform-action action (Optional) Specifies the action to take on packets that conform to the
police rate limit. See the “Usage Guidelines” section for the actions you
can specify.
exceed-action action (Optional) Specifies the action to take on packets that exceed the rate
limit. See the “Usage Guidelines” section for the actions you can specify.
violate-action action (Optional) Specifies the action to take on packets that continuously
exceed the police rate limit. See the “Usage Guidelines” section for the
actions you can specify.
Release Modification
12.3(7)T This command was introduced.
12.2(18)SXD1 Support for this command was introduced on the Supervisor Engine 720.
12.2(25)S This command was integrated into Cisco IOS Release 12.2(25)S.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(31)SB2 This command was integrated into Cisco IOS Release 12.2(31)SB2 and
implemented on the Cisco 10000 series router.
12.3(7)T This command was introduced.
12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.
Table 1-6 action Argument Values
Action Description
drop Drops the packet. This is the default action for traffic that
exceeds or violates the committed police rate.
set-clp-transmit value Sets the ATM Cell Loss Priority (CLP) bit on the ATM cell.
Valid values are 0 or 1.
Page view 318
1 ... 318 319 320 ... 710

Comments to this Manuals

No comments