Cisco MWR 2941 Installation Manual Page 271

  • Download
  • Add to my manuals
  • Print
  • Page
    / 710
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 270
-271
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
network-clock output-source
network-clock output-source
To transmit clocking to an external timing source using a timing output interface, use the network-clock
output-source command in configuration mode. To disable clocking output, use the no form of this
command.
network-clock output-source line priority {interface interface-name slot/card/port | controller
{t1 | e1} slot/card/port} {external slot/card/port [t1 {sf | esf | d4} | e1 [crc4| fas| cas [crc4] ] |
j1| 2m | 10m]
no network-clock output-source line priority {interface interface-name slot/card/port |
controller {t1 | e1} slot/card/port} {external slot/card/port [t1 {sf | esf | d4} | e1 [crc4| fas| cas
[crc4] ] | j1| 2m | 10m]
Syntax Description priority The priority of the clock source. The range is from 1 to 250.
interface Specifies the interface connected to the clock input.
interface-name The name of the interface connected to the clock input.
slot The slot of Router/Switch where the clock source is present.
card The bay in which card is inserted.
port The port of the card.
controller Specifies the controller connected to the clock source.
t1 Specifies the T1 controller.
e1 Specifies the E1 controller.
slot The slot of Router/Switch where the clock source is present.
card The bay in which card is inserted.
port The port of the card.
external Specifies an external interface.
slot The slot of Router/Switch where the clock source is present.
card The bay in which card is inserted.
port The port of the card.
t1 Specifies a T1 interface.
sf Specifies SF framing on the T1 interface.
esf Specifies T1 ESF framing on the T1 interface.
d4 Specifies D4 framing on the T1 interface.
e1 Specifies an E1 interface.
crc4 Specifies CRC4 framing on the E1 interface.
fas Specifies FAS framing on the E1 interface.
cas Specifies CAS signaling on a T1 interface.
crc4 Specifies CRC4 framing on the E1 interface.
j1 Specifies the J1 interface.
2m Specifies the 2 MHz interface.
10m Specifies the 10 MHz interface.
Page view 270
1 ... 270 271 272 ... 710

Comments to this Manuals

No comments