Cisco MWR 2941 Installation Manual download pdf (Page 414)

100

101

-414

Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR

OL-26895-01

Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR

set cos-inner

To mark the inner class of service field in a bridged frame, use the set cos-inner command in policy-map

class configuration mode. To remove marking of the inner CoS field, use the no form of this command.

set cos-inner cos-value

no set cos-inner cos-value

Syntax Description

Defaults No default behavior or values.

Command Modes Policy-map class configuration

Command History

Usage Guidelines This command was introduced in Cisco IOS Release 12.2(33)SRA to support marking of the inner CoS

value when using multipoint bridging (MPB) features on the Enhanced FlexWAN module, and when

using MPB features on SPAs with the Cisco 7600 SIP-200 and Cisco 7600 SIP-400 on the Cisco 7600

series router.

This command is not supported on the Cisco 7600 SIP-600.

On the Cisco 7600 SIP-200, this command is not supported with the set cos command on the same

interface.

For more information about QoS and the forms of marking commands supported by the SIPs on the

Cisco 7600 series router, refer to the Cisco 7600 Series SIP, SSC, and SPA Software Configuration

Guide.

Examples The following example shows configuration of a QoS class that filters all traffic matching on VLAN 100

into a class named “vlan-inner-100.” The configuration shows the definition of a policy-map (also named

“vlan-inner-100”) that marks the inner CoS with a value of 3 for traffic in the vlan-inner-100 class. Since

marking of the inner CoS value is only supported with bridging features, the configuration also shows

the service policy being applied as an output policy to a serial SPA interface that bridges traffic into

VLAN 100 using the bridge-domain command:

Router(config)# class-map match-all vlan-inner-100

Router(config-cmap)# match vlan inner 100

Router(config-cmap)# exit

cos-value IEEE 802.1q CoS value from 0–7.

Release Modification

12.2(33)SRA This command was introduced.

12.4(20)MR This command was integrated into Cisco IOS Release 12.4(20)MR.

12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.

15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.

1 ... 413 414 415 ... 710

Comments to this Manuals

No comments

Cisco MWR 2941 Installation Manual Page 414

Comments to this Manuals

Related products and manuals for Networking Cisco MWR 2941