Cisco MWR 2941 Installation Manual download pdf (Page 365)

100

101

-365

Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR

OL-26895-01

Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR

queue-limit

To specify or modify the queue limit (size) for a class in bytes, milliseconds (ms), or packets use the

queue-limit command in policy-map class configuration mode. To remove the queue limit from a class,

use the no form of this command.

queue-limit queue-limit-size [bytes | ms |packets]

no queue-limit

Syntax Description

Command Default The default behavior of the queue-limit command for class queues with and without weighted random

early detection (WRED) is:

• Class queues with WRED—The router uses the default queue limit of two times the largest WRED

maximum threshold value, rounded to the nearest power of 2.

• Priority queues and class queues without WRED—The router has buffers for up to 50 ms of 256-byte

packets at line rate, but not fewer than 32 packets.

Command Modes Policy-map class configuration (config-pmap-c)

Command History

queue-limit-size The maximum size of the queue. The maximum varies according to the

optional unit of measure keyword specified (bytes, ms, or packets).

Note If an optional unit of measure is not indicated, the default unit of

measure is packets.

bytes (Optional) Indicates that the unit of measure is bytes. Valid range for bytes

is a number from 1 to 8192000.

ms (Optional) Indicates that the unit of measure is milliseconds. Valid range

for milliseconds is a number from 1 to 3400.

packets (Optional) Indicates that the unit of measure is packets. Valid range for

packets is a number from 1 to 32768 but can also vary by platform and

release.

Release Modification

12.0(5)T This command was introduced.

12.0(5)XE This command was integrated into Cisco IOS Release 12.0(5)XE. Support

for VIP-enabled Cisco 7500 series routers was added.

12.0(17)SL This command was implemented on the Cisco 10000 series router.

12.1(5)T This command was implemented on the VIP-enabled Cisco 7500 series

routers.

12.2(16)BX This command was introduced on the ESR-PRE2.

12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.

12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.

12.3(7)XI This command was integrated into Cisco IOS Release 12.3(7)XI.

1 ... 364 365 366 ... 710

Comments to this Manuals

No comments

Cisco MWR 2941 Installation Manual Page 365

Comments to this Manuals

Related products and manuals for Networking Cisco MWR 2941