Cisco MWR 2941 Installation Manual Page 601
- Page / 710
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
-601
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
show policy-map interface
Traffic Policing: Example
The following is sample output from the show policy-map interface command. This sample displays
the statistics for the serial 2/0 interface on which traffic policing has been enabled. The committed
(conform) burst (bc) and excess (peak) burst (be) are specified in milliseconds (ms).
Router# show policy-map interface serial2/0
Serial2/0
Service-policy output: policy1 (1050)
Match Match criteria specified for the class of traffic. Choices include criteria
such as the Layer 3 packet length, IP precedence, IP DSCP value, MPLS
experimental value, access groups, and quality of service (QoS) groups.
For more information about the variety of match criteria that are available,
see the “Classifying Network Traffic” module in the Cisco IOS Quality of
Service Solutions Configuration Guide.
Traffic Shaping Indicates that traffic shaping based on a percentage of bandwidth has been
enabled.
Target/Average Rate Rate (percentage) used for shaping traffic and the number of packets
meeting that rate.
Byte Limit Maximum number of bytes that can be transmitted per interval. Calculated
as follows:
((Bc+Be) /8 ) x 1
Sustain bits/int Committed burst (Bc) rate.
Excess bits/int Excess burst (Be) rate.
Interval (ms) Time interval value in milliseconds (ms).
Increment (bytes) Number of credits (in bytes) received in the token bucket of the traffic
shaper during each time interval.
Adapt Active Indicates whether adaptive shaping is enabled.
Queue Depth Current queue depth of the traffic shaper.
Packets Total number of packets that have entered the traffic shaper system.
Bytes Total number of bytes that have entered the traffic shaper system.
Packets Delayed Total number of packets delayed in the queue of the traffic shaper before
being transmitted.
Bytes Delayed Total number of bytes delayed in the queue of the traffic shaper before
being transmitted.
Shaping Active Indicates whether the traffic shaper is active. For example, if a traffic
shaper is active, and the traffic being sent exceeds the traffic shaping rate,
a “yes” appears in this field.
1. A number in parentheses may appear next to the service-policy output name, class-map name, and match criteria
information. The number is for Cisco internal use only and can be disregarded.
Table 1-54 show policy-map interface Field Descriptions—Configured for Percentage-Based
Policing and Shaping (with Traffic Shaping Enabled)
1
(continued)
Field Description
- Release 15.1(3)MR 1
- Configuring a Policy Map 14
- Restrictions 15
- Policy Map Configuration Mode 27
- Class Characteristics 27
- Predefined Default Class 27
- Tail Drop or WRED 27
- Fragments 28
- If ID Choice Is Anything Else 72
- Unique Device Identifier 73
- Cisco HWIC-4SHDSL 88
- SNAP Encapsulation Example 96
- OL-26895-01 105
- • n393—1 to 10. Default is 4 133
- • proxy-register 187
- • list access-list 187
- • route-map map-name 187
- Support for Serial Lines 194
- Syntax Description 195
- Keepalive Time Interval 203
- Line Failure 203
- Dropped Packets 203
- DSCP Values 226
- Match Packets on DSCP Values 227
- • match access-group 231
- • match input-interface 231
- • match mpls experimental 231
- • match protocol 231
- Precedence Values and Names 233
- IPv4-Specific Traffic Match 233
- IPv6-Specific Traffic Match 234
- Support Restrictions 237
- ATM Mode Example 247
- CAS Mode Example 247
- Router(config)# no mpls ip 250
- Release 12.2(33)SRB 259
- • QL-PRC 275
- • QL-SSU-A 275
- • QL-SSU-B 275
- • QL-SEC 275
- • QL-DNU 275
- All Supported Platforms 303
- Hierarchical Policy Maps 304
- How Bandwidth Is Calculated 305
- • conform-action is transmit 311
- • exceed-action is drop 311
- • violate-action is drop 311
- Token Buckets 314
- Updating Token Buckets 315
- Marking Traffic 315
- Two-Rate Policing 316
- Syntax for Percent 318
- Command Application 332
- • Data encapsulation type 334
- • Control protocol 334
- • 4—1 packet every 16 seconds 336
- • 3—1 packet every 8 seconds 336
- • 2—1 packet every 4 seconds 336
- • 1—1 packet every 2 seconds 336
- • 0—1 packet every second 336
- Command Description 341
- Router(config)# exit 358
- Weighted Fair Queueing 366
- • Control network loops 376
- • Handle link failures 376
- • Improve convergence time 376
- the following adapters: the 409
- to specify the “from-field” 412
- • EF (expedited forwarding) 420
- Precedence Value and Queueing 421
- 2. ip tos reflect 429
- 3. ip tos tos-value 429
- Command Compatibility 440
- Bit Settings 440
- Precedence Value 441
- Committed Information Rate 449
- IMA Group 456
- M-PAIR Group 456
- 1-PAIR and 2-PAIR Group 456
- DSL Group with 1 Pair 458
- DSL Group with 2 Pairs 458
- DSL Group with 3 Pairs 458
- DSL Group with 4 Pairs 458
- • Interface name and number 471
- • Identifier (group ID) 475
- ADSL: Example 490
- • Domain name 495
- • Domain index 495
- • Domain level 495
- Field Description 504
- Reliability Errors 524
- Protocol Errors 524
- UNI Id Identifier of the UNI 526
- EVC Id Identifier of the EVC 526
- • Local and remote OAM mode 528
- • Remote platform identity 528
- • Remote loopback events 531
- Traffic Policing: Example 583
- Tunnel Marking: Example 588
- ATM Shared Port Adapter 590
- (continued) 595
- Policing 597
- Policing and Shaping 599
- Traffic Shaping: Example 600
- UDP encapsulation 613
- • priority is 128 647
- Router(config-if)# 648
- • Up to 2 queues 670
- • Up to 2 interfaces 670
- • 1 queue and 1 interface 670
- Router(config-if)# switchport 672
- GRE Tunneling Example 693
- Peak Value 705
- Average Value 705
- Burst Value 705
- Activating the Primary Member 709
- Activating the Backup Member: 709
Related products and manuals for Networking Cisco MWR 2941
Networking Cisco WMP110 User Manual
(2 pages)
(2 pages)
Networking Cisco Ex SERIES User Manual
(15 pages)
(15 pages)
Networking Cisco Soho series User Manual
(4 pages)
(4 pages)
Networking Cisco AS2509-RJ User Manual
(26 pages)
(26 pages)
Networking Cisco WKPC54G User Manual
(2 pages)
(2 pages)
Networking Cisco Dial NMS User Manual
(8 pages)
(8 pages)
Networking Cisco DMA2100 User Manual
(3 pages)
(3 pages)
(2 pages)© 2020, manymanuals.com. All rights reserved. | 0.030 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals