Cisco SCE 1000 2xGBE User's Guide download pdf (Page 100)

Chapter 4 Installation and Startup

System Configuration

SCE 1000 2xGBE Release 2.0.10 User Guide

4-38 OL-7117-02

EXAMPLE:

This example illustrates a common access control scenario. Let us assume the following:

• We want to permit every station to access the SCE on the management port (e.g. ping, SNMP

polling etc.).

• We want to restrict Telnet access to only a few permitted stations.

We therefore need to create two access control lists:

• For general IP access: permit access to all IP addresses.

• For Telnet: permit access to the specified IP address, and deny to all others.

ACL #1 = permit any IP address. Assign to IP access.

ACL #2 = permit access to 10.1.1.0, 10.10.10.1, deny to all others. Assign to Telnet access.

Would you like to enter the Access lists configuration menu? [no]: y

Would you like create new Access lists or modify existing lists? [no]: y

Enter ACL number: 1

Does this entry permit access? [yes]:

Enter IP address or the word ‘any’ to denote any IP address: any

This entry matches every IP address, no use in adding more entries to this

list.

Would you like to configure another list? [no]: y

Enter ACL number: 2

Does this entry permit access? [yes]:

Enter IP address or the word ‘any’ to denote any IP address: 10.1.1.0

Enter wildcard bits: 0.0.0.0

Would you like to add another entry to this list? [no]:y

Does this entry permit access? [yes]:

Enter IP address or the word ‘any’ to denote any IP address: 10.10.10.1

Enter wildcard bits: 0.0.0.0

Would you like to add another entry to this list? [no]:y

Does this entry permit access? [yes]:n

Enter IP address or the word ‘any’ to denote any IP address: any

This entry matches every IP address, no use in adding more entries to this

list.

Would you like to configure another list? [no]:

Enter IP access-class [0]: 1

Enter Telnet access-class [0]: 2

EXAMPLE 2:

This example skips the first section of the dialog (creating/modifying), and proceeds directly to

assign existing ACLs.

Would you like to enter the Access lists configuration menu? [no]: y

Would you like create new Access lists or modify existing lists? [no]:

Enter IP access-class [0]: 10

Enter Telnet access-class [0]: 22

Step 8: Configuring SNMP

Managing the SCE 1000 is possible also via a Network Management System (NMS) that supports

SNMP. By default, SNMP is disabled on the SCE 1000. (See SNMP Configuration and

Management (on page 6-31) for further information.)

To enable SNMP management you must configure the following basic SNMP parameters:

• SNMP traps status and managers.

1 ... 99 100 101 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 100

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE