Chapter 6 Control Configuration
Entering LineCard Interface Configuration Mode
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 6-47
To undo an upgrade of an application:
Step 1 From the SCE 1000(config if)# prompt, type pqi rollback file
filename and press Enter.
The upgrade of the specified pqi file is undone and the SCE 1000(config if)#
prompt appears.
Note that this may take up to 5 minutes.
To display the last pqi file that was installed:
Step 1 From the SCE 1000# prompt, type show pqi last-installed and press Enter.
The name of the last pqi file that was installed is displayed and the SCE 1000# prompt
appears.
Configuring the Currently Installed Application
Use the following commands to:
• Validate the configuration file
• Configure the currently installed application by applying the configuration file
• Display the name of the last configuration file that was applied
The following commands are relevant for configuring the currently installed application:
• scm apply file
• scm validate file
• show scm last-applied
To validate a configuration file:
Step 1 From the SCE 1000# prompt, type scm validate file filename and press
Enter.
The specified configuration file is checked and the SCE 1000# prompt appears.
To apply a configuration file:
Step 1 From the SCE 1000(config if)# prompt, type scm apply file filename
and press Enter.
Comments to this Manuals