Cisco SCE 1000 2xGBE User's Guide download pdf (Page 307)

100

101

Appendix A

LineCard Interface Configuration Mode Commands

SCE 1000 2xGBE Release 2.0.10 User Guide

OL-7117-02 A-37

attack-detector <number> access-list

Enables the specified attack detector and assigns an access control list (ACL) to it.

Authorization admin

Mode LineCard Interface Configuration

ARAMETERS

access-list The number of the ACL containing the IP addresses selected by this

detector

comment For documentation purposes

XAMPLE:

The following example enables attack detector number "2", and assigns ACL "8".

SCE 1000(config if)# attack-detector 2 access-list 8

[no] attack-filter

Enables/disables attack detection.

Default enabled

Authorization admin

Mode LineCard Interface Configuration

XAMPLE:

The following example disables attack detection.

SCE 1000(config if)#no attack-filter

[no] attack-filter subscriber-notification ports

Specifies up to three ports as subscriber notification ports. TCP Traffic from the subscriber side to

these ports will never be blocked by the attack filter, leaving them always available for subscriber

notification.

Use the [no] form of this command to remove all ports from the subscriber notification port list.

Authorization admin

Mode LineCard Interface Configuration

XAMPLE:

The following example defines adds ports to the subscriber notification port list.

SCE 1000(config if)# attack-filter subscriber-notification ports 100,101,102

1 ... 306 307 308 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 307

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE