Cisco SCE 1000 2xGBE User's Guide download pdf (Page 254)

100

101

Chapter 10 Troubleshooting

RDR Reports

SCE 1000 2xGBE Release 2.0.10 User Guide

10-6 OL-7117-02

Symptom How to look for the

specific cause

Possible Cause Resolution

CLI Commands:

show telnet sessions

Too many Telnet connections

(up to 5 concurrent sessions are

supported)

Close one or more of

the open Telnet

sessions

CLI Commands:

show ip default-gateway

Default gateway is incorrect

(when the host used as client is

not in the same network as the

SCE Platform)

Check / reconfigure

default gateway.

Refer to Default

Gateway. ("Default

Gateway" on page 6-8)

CLI commands:

show ip route <host-ip-

address>

Routing tables are incorrectly

configured (when the host used

as client is not in the same

network as the SCE Platform,

and there is more than one

gateway on the SCE Platform

network)

Check / reconfigure

routing tables.

Refer to IP Routing

Table (on page 6-7).

CLI commands:

show access-lists

show line vty access-class

show ip access-class

Host is not a member of a valid

access-list

Check / reconfigure

access-list.

Refer to Configuring

Access Control Lists

(ACLs) (on page 6-2).

Telnet

connection

terminates

automatically

CLI commands:

show line vty timeout

There is a timeout configured

on Telnet sessions

Check / reconfigure

line timeout (use no

timeout to disable

timeout).

Refer to Telnet

Timeout.

RDR Reports

The main cause for missing RDR reports can be a management link problem. For the

troubleshooting of management link problems, see section Management Link (on page 10-5) in

this chapter.

The following table describes the different cases that might lead to a RDR reporting problem,

assuming that the management link is functional (answers ping).

1 ... 253 254 255 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 254

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE