Cisco SCE 1000 2xGBE User's Guide Page 204

  • Download
  • Add to my manuals
  • Print
  • Page
    / 490
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 203
Chapter 7 Line Configuration
Configuring Traffic Rules and Counters
SCE 1000 2xGBE Release 2.0.10 User Guide
7-10 OL-7117-02
Action = ignore (required since traffic-counter = none)
Since it is not TCP/UDP, port and flags are not applicable.
The only action performed will be Ignore.
SCE 1000 (config if)# traffic-rule rule3 IP-addresses all protocol IS-IS
direction upstream traffic-counter none action ignore
To delete a traffic rule:
Step 1 From the SCE 1000(config if)# prompt, type no traffic-rule name
<name>
Note that a traffic counter cannot be deleted if it is used by any existing traffic rule.
To delete all existing traffic rules:
Step 1 From the SCE 1000(config if)# prompt, type no traffic-rule all
Managing Traffic Rules and Counters
Use these commands to display existing traffic rule configuration, as well as traffic counter
configuration (packets/bytes and the name of the rule using the counter) and traffic counter value.
You can also reset a specific counter or all counters.
To view a specified traffic rule:
Step 1 From the SCE 1000# prompt, type show interface linecard 0 traffic-
rule name <rule-name>
To view all existing traffic rules:
Step 1 From the SCE 1000# prompt, type show interface linecard 0 traffic-
rule all
Page view 203
1 ... 203 204 205 ... 490

Comments to this Manuals

No comments