Cisco SCE 1000 2xGBE User's Guide download pdf (Page 112)

100

101

Chapter 4 Installation and Startup

Connecting the line ports to the network

SCE 1000 2xGBE Release 2.0.10 User Guide

4-50 OL-7117-02

Figure 4-20: External Splitting Topology

Configuring the GBE Interface Parameters

Configuring Auto-Negotiation

By default, the SCE 1000 line interface ports are configured with auto-negotiation enabled.

However, when using an external splitter, the auto-negotiation must be disabled.

Note

In order to prevent errors when in bypass mode, the system must be configured so that the speed and

duplex of both line interfaces is the same.

Note

If you change any parameters, you must save the new configuration settings.

Type copy running-config startup-config, and press Enter.

To configure GBE auto-negotiation for speed and duplex for the first GBE port (subscriber side)

interface:

Step 1 To enter the Global Configuration Mode, at the SCE 1000# prompt, type configure, and

press Enter.

The SCE 1000(config)# prompt appears.

Step 2 To enter the first GBE port interface, type interface GigabitEthernet 0/1, and press

Enter.

1 ... 111 112 113 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 112

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE