Cisco SCE 1000 2xGBE User's Guide download pdf (Page 72)

100

101

Chapter 4 Installation and Startup

Installation

SCE 1000 2xGBE Release 2.0.10 User Guide

4-10 OL-7117-02

Step 2: Attaching the Crossrail Supports to the Rack

When mounting in a rack with four posts (front and back) the two crossrail supports are mounted

one on each side of the rack. The SCE 1000 then slides into these crossrails, which support the

weight of the unit.

Note

Cisco recommends that you allow at least 1 or 2 inches (2.54 or 5.08 cm) of vertical clearance between

the SCE 1000 and any equipment directly above and below it.

To install the crossrail supports on a rack with both front and back posts:

Step 1 Assemble the two crossrail supports as illustrated below. Use three screws for each

crossrail assembly.

Make sure that they are oriented so that both crossrails will support the SCE 1000 when

they are attached to the rack.

Figure 4-6: Assembling the Slider Brackets

Step 2 Align the crossrail supports with the side of the rack, parallel to the floor.

Step 3 Insert and tighten two screws to the front posts or mounting strips of the rack

1 ... 71 72 73 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 72

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE