Regulatory Compliance and Safety Information
Warning Definition Statement
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 xxiii
FCC Warning
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Restricted Area Warning (DC platform only)
Warning:
This unit is intended for installation in restricted access areas. A restricted access area is where access
can only be gained by service personnel through the use of a special tool, lock and key, or other
means of security, and is controlled by the authority responsible for the location.
Wrist Strap Warning
Warning:
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the back plane with your hand or any metal tool, or you could shock yourself.
Power Disconnection Warning
Warning:
Before working on a system that has an on/off switch, turn OFF the power and unplug the power
cord.
Power Supply Warning
Warning:
Do not touch the power supply when the power cord is connected. For systems with a power switch,
line voltages are present within the power supply even when the power switch is off and the power
cord is connected. For systems without a power switch, line voltages are present within the power
supply when the power cord is connected.
Power Supply Disconnection Warning
Warning:
Before working on a chassis or working near power supplies, unplug the power cord on AC units;
disconnect the power at the circuit breaker on DC units.
Comments to this Manuals