Cisco SCE 1000 2xGBE User's Guide Page 161

  • Download
  • Add to my manuals
  • Print
  • Page
    / 490
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 160
Chapter 6 Control Configuration
SNTP
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 6-15
EXAMPLE:
The following example shows how to enable an SNTP server at IP address 128.182.58.100.
SCE 1000(config)# sntp server 128.182.58.100
Disabling SNTP unicast client
To disable the SNTP unicast client and remove all servers from the client list:
Step 1 From the SCE 1000(config)# prompt, type no sntp server all, and press
Enter.
All SNTP unicast servers are removed, preventing unicast SNTP query.
To remove one SNTP servers from the client list:
Step 1 From the SCE 1000(config)# prompt, type no sntp server <address>, and
press Enter, where <address> is the IP address of the SNTP server.
The specified SNTP unicast server is removed.
Defining the SNTP unicast update interval
To define the interval for SNTP update queries:
Step 1 From the SCE 1000(config)# prompt, type sntp update-interval
<interval>, where <interval> is the time in seconds between updates (64 through
1024), and press Enter.
The SNTP unicast client will query the server at the defined intervals.
EXAMPLE:
The following example shows how to set the SNTP update interval for 100 seconds.
SCE 1000(config)# sntp update-interval 100
Page view 160
1 ... 160 161 162 ... 490

Comments to this Manuals

No comments