Cisco SCE 1000 2xGBE User's Guide download pdf (Page 93)

100

101

Chapter 4 Installation and Startup

System Configuration

SCE 1000 2xGBE Release 2.0.10 User Guide

OL-7117-02 4-31

• To enable password encryption, type y and press Enter.

EXAMPLE:

Following is an example of changing all passwords. Password encryption is not enabled (default).

Enter a User password [cisco]: userin

Enter an Admin password [cisco]: mng123

Enter a Root password [cisco]: cistech

Enable passwords encryption? [no]:

Step 4: Configuring Time Settings

The time settings menu configures all time and date related parameters in the system. The time

settings menu includes the following:

• Time zone

• Local time

• Date

• SNTP menu

You must enter the time setting menu in order to configure SNTP settings. You may choose to

skip the time settings menu if you wish to accept all default values.

Note

Unlike all other settings defined in the system configuration, setting the time is done immediately and

not at the end of the setup process.

For more information on clocks and time zones, see Time Clocks and Time Zone (on page 6-11).

For more information on SNTP, see SNTP (on page 6-13).

To configure the time settings:

Step 1 Enter the time settings menu.

Would you like to enter the Time settings menu? [no]: y

Type y and press Enter.

The time settings dialog begins.

Step 2 Type the time zone abbreviation and press Enter.

Enter time zone name [UTC]: CET

Step 3 Type the minutes offset from UTC and press Enter.

Enter time zone minutes offset from UTC: 60

The local time and date are displayed, and you are asked whether you want to change

them.

The local time and date is 15:00:01 CET FRI 01 July 2002

Would you like to set a new time and date? [no]:

Step 4 If the time and date are correct, go to step 5.

1 ... 92 93 94 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 93

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE