Cisco SCE 1000 2xGBE User's Guide download pdf (Page 190)

100

101

Chapter 6 Control Configuration

Entering LineCard Interface Configuration Mode

SCE 1000 2xGBE Release 2.0.10 User Guide

6-44 OL-7117-02

The default of this command is set to auto. Changing this configuration takes effect

only if the duplex mode is not configured to auto.

EXAMPLE:

The following example shows how to use this command to configure the FastEthernet

Management port to 100 Mbps speed.

SCE 1000(config if)#speed 100

Table 6-3 Interface State Relationship to Speed and Duplex

Speed Duplex Actual FEI state

Auto Auto Auto negotiation

Auto Full Auto negotiation

Auto Half Auto negotiation

10 Auto Auto-negotiation (duplex only)

10 Full 10 Mbps and Full duplex

10 Half 10 Mbps and half duplex

100 Auto Auto-negotiation (speed only)

100 Full 100 Mbps and full duplex

100 Half 100 Mbps and half duplex

Entering LineCard Interface Configuration Mode

The following procedure is for entering Line Card Interface Configuration mode. The procedures

for entering the other interfaces are the same except for the interface command as described above

and in CLI Command Reference (on page A-1).

To enter LineCard Interface Configuration mode:

Step 1 To enter Global Configuration Mode, at the SCE 1000# prompt, type configure, and

press Enter.

The SCE 1000(config)# prompt appears.

Step 2 Type interface LineCard 0, and press Enter.

The SCE 1000(config if)# prompt appears.

Step 3 To return to Global Configuration Mode, type exit and press Enter.

The SCE 1000(config)# prompt appears.

Step 4 To exit Global Configuration Mode, type exit and press Enter.

The SCE 1000# prompt appears.

1 ... 189 190 191 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 190

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE