Chapter 4 Installation and Startup
Connecting the Local Console
SCE 1000 2xGBE Release 2.0.10 User Guide
4-24 OL-7117-02
Connecting the Local Console
Even if you will be managing the SCE 1000 from a remote location, you must first connect the
unit to a local console and configure the initial settings for the SCE 1000 to support remote
management. When the initial connection is established, the setup utility will run automatically,
prompting you to perform the initial system configuration.
Setting Up the Local Console
This section provides instructions for setting up your local terminal at your workstation, to enable
you to perform the initial system configuration of the SCE 1000 system using the setup utility.
Figure 4-17: Connecting to the Local Console
Make sure that the terminal configuration is as follows:
• 9600 baud
• 8 data bits
• No Parity
• 1 stop bits
• No flow control
Comments to this Manuals