Cisco SCE 1000 2xGBE User's Guide download pdf (Page 172)

100

101

Chapter 6 Control Configuration

The RDR Formatter

SCE 1000 2xGBE Release 2.0.10 User Guide

6-26 OL-7117-02

Configuring the destinations with the proper priorities for each category, as well as configuring all

the other RDR formatter parameters, may be approached in several different ways, and may take

some planning. Refer to the examples below for illustrations of some of the issues involved in

configuring categories.

To configure an RDR Formatter category name:

Step 1 From the SCE 1000(config)# prompt, type RDR-Formatter category-

number 1|2 name <category-name>, and press Enter.

The name for the specified category number is defined. This category name can then be

used in any RDR-formatter command instead of the category number.

To configure a RDR Formatter destination and assign it to a category:

Step 1 From the SCE 1000(config)# prompt, type RDR-Formatter destination

<IP address> port <port-number> category [name <category-

name> |number [1|2]] [priority <priority(1-100)>] [category

[name <category-name> |number [1|2]] [priority <priority(1-

100)>]], and press Enter.

The RDR Formatter destination is defined. A different priority may be assigned to each

category. (This can be done in one command.) If RDRs from the specified category

should be sent to this destination, the priority for the category should be high. If the

RDRs from the specified category should not be sent to this destination, the priority

should be low.

Note that within each category the priorities must be unique for each destination.

1 ... 171 172 173 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 172

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE