Cisco SCE 1000 2xGBE User's Guide download pdf (Page 94)

100

101

Chapter 4 Installation and Startup

System Configuration

SCE 1000 2xGBE Release 2.0.10 User Guide

4-32 OL-7117-02

If the time and date are not correct, answer yes to the above question, and press Enter.

Would you like to set a new time and date? [no]: y

Confirm your response and type the new time and date.

This change will take effect immediately both on the system clock and the

calendar; it will also set the time zone you entered. Are you sure?

[yes/no]: y

Enter new local time and date: 14:00:01 1 July 2002

Time zone was successfully set.

The system clock and the calendar were successfully set.

Step 5 You are asked whether you wish to enter the SNTP configuration menu.

If you do not wish to configure the SNTP, skip the rest of this section and go to Step 5:

Configuring the DNS Settings (on page 4-33).

To enter the SNTP configuration dialog, type y, and press Enter

Would you like to enter the SNTP configuration menu? [no]: y

Step 6 Configure the SNTP broadcast client. By default the SNTP broadcast client is not

enabled.

• To disable the SNTP broadcast client, press Enter.

• To enable the SNTP broadcast client, type y and press Enter.

Enable SNTP broadcast client? [no]:

Step 7 Define the time interval between unicast updates.

• To accept the displayed default value, press Enter.

• To change the value, type the desired number of seconds (64 through 1024) and press

Enter.

Enter time interval in seconds between unicast updates [1024]:

Step 8 You may enter an IP address for the SNTP unicast server. Type in the hostname or the IP

address in the form x.x.x.x, and press Enter

Would you like to configure SNTP unicast servers? [no]: y

Enter IP address or hostname of SNTP unicast server: 10.1.1.1

1 ... 93 94 95 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 94

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE