Cisco SCE 1000 2xGBE User's Guide Page 153

  • Download
  • Add to my manuals
  • Print
  • Page
    / 490
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 152
Chapter 6 Control Configuration
IP Configuration
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 6-7
Step 2 Type snmp-server community community-string, where the community
string is a security string that identifies a community of managers that are able to
access the SNMP server.
You must define at least one community string in order to allow SNMP access. For
complete information on community strings see Configuring SNMP Community Strings
(on page 6-33).
Disabling SNMP
To disable SNMP access:
Step 1 From the SCE 1000(config)# prompt, type no snmp-server.
IP Configuration
IP Routing Table
For handling IP packets on the out of band FE port, the SCE 1000 maintains a static routing table.
When a packet is sent, the system checks the routing table for proper routing, and forwards the
packet accordingly. In cases where the SCE 1000 cannot determine where to route a packet, it
sends the packet to the default gateway.
SCE 1000 supports the configuration of the default gateway as the default next hop router, as well
as the configuration of the routing table to provide different next hop routers for different subnets
(for maximum configuration of 10 subnets).
The following sections illustrate how to use CLI commands to configure various parameters.
The following commands are relevant to IP Routing tables:
ip route prefix mask next-hop
no ip route all
no ip route prefix mask
show ip route
show ip route prefix
show ip route prefix mask
Page view 152
1 ... 152 153 154 ... 490

Comments to this Manuals

No comments