Cisco SCE 1000 2xGBE User's Guide Page 53

  • Download
  • Add to my manuals
  • Print
  • Page
    / 490
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 52
Chapter 3 Command Line Interface
Authorization and Command Levels (Hierarchy)
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 3-7
The LineCard interface configures the main functionality of viewing and handling traffic on
the line.
Fast Ethernet Management: Interface FastEthernet 0/0
The FastEthernet Management Interface configures the settings for the interface to other
network elements within the system. This interface should be connected to the internal
Ethernet within the operators site.
Gigabit Ethernet Link: Interface GigabitEthernet 0/1 or 0/2
The GigabitEthernet Interface mode configures the settings for the GigabitEthernet interface
to the Internet traffic on the wire. Each of the two ports can be set individually.
Line Configuration Mode: Line vty 0
Line Configuration Mode enables you to configure Telnet parameters.
Configuring the Physical Network Interface Parameters
The SCE 1000 system contains the following network interfaces:
FastEthernet Management: Interface FastEthernet (0/0)
The FastEthernet Management Interface mode configures the settings for the interface other
network elements within the system. This interface should be connected to the internal
Ethernet within the operator site.
GigabitEthernet: Interface GigabitEthernet (0/1 or 0/2)
The GigabitEthernet Interface mode configures the settings for the GigabitEthernet interface
to the Internet traffic on the wire. Each of the two ports can be set individually.
Note
You must specify Slot number and Interface number when referencing the FastEthernet Interface or the
GigabitEthernet Interface. Slot number is always 0, and the interfaces are numbered as follows:
GigabitEthernet Line Interfaces: 1,2
FastEthernet Management Interface: 0
Entering FastEthernet (Management) Interface Configuration Mode
Before you can configure the FastEthernet parameters for the management interface, you must be
in the FastEthernet Management Interface Configuration Mode.
To enter FastEthernet Management Interface Configuration Mode:
Step 1 To enter Global Configuration Mode, type configure and press Enter.
The SCE 1000(config)# prompt appears.
Step 2 Type interface FastEthernet 0/0 and press Enter.
The SCE 1000(config if)# prompt appears.
The system prompt changes to reflect the higher level mode.
Page view 52
1 ... 52 53 54 ... 490

Comments to this Manuals

No comments