Cisco SCE 1000 2xGBE User's Guide Page 326

  • Download
  • Add to my manuals
  • Print
  • Page
    / 490
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 325
Appendix A
GigaBitEthernet Interface Configuration Mode Commands
SCE 1000 2xGBE Release 2.0.10 User Guide
A-56 OL-7117-02
queue queue-number bandwidth bandwidth burst-size burstsize
Sets the queue shaping.
Default Bandwidth=100000K (100 Mega bps), burst size=8000 (8 K bytes)
Authorization admin
Mode GigabitEthernet Interface Configuration
P
ARAMETERS
queue-number Queue-number from 1–4, where 4 is the highest priority (fastest).
1=BE, 2, 3=AF, and 4=EF. BE is the best effort queue, that is the
lowest priority. EF is the Expedited Forwarding queue, that is the
highest priority forwarding. The AF (Assured Forwarding) queues
are middle-priority, with 3 being a higher priority queue, that is,
packets from queue 3 are transferred faster than those in queue 2.
bandwidth Bandwidth measured in kbps. 0 disables packet transmission from
the queue. The maximum bandwidth is determined by the line rate.
Bandwidth is set in resolutions of ~140Kbps, that is rounded to the
nearest multiple of approximately 140 Kbps.
burstsize Burst size in bytes, from 0–16000000.
U
SAGE GUIDELINES
This command is valid for the line interfaces only, Interface GigabitEthernet
0/#.
E
XAMPLES:
The following sets queue shaping for queue 1.
SCE 1000(config-if)#queue 2 bandwidth 20000 burstsize 1000
SCE 1000(config-if)#
Page view 325
1 ... 325 326 327 ... 490

Comments to this Manuals

No comments