Cisco SCE 1000 2xGBE User's Guide Page 259

  • Download
  • Add to my manuals
  • Print
  • Page
    / 490
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 258
Chapter 10 Troubleshooting
GBE Interfaces Connectivity
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 10-11
Symptom How to look for the
specific cause
Possible Cause Resolution
Peer does not
receive traffic
from SCE
Platform
GBE link is up
and Tx LED is
flashing
correctly
GBE interface link
LED is continuous
green
GBE interface Tx LED
is flashing
CLI commands:
show interface
GigaBitEthernet
0/# counters
Check printout of this
command for: “Out
unicast packet”. This
counter should be
constantly incrementing.
show interface
GigaBitEthernet
0/#
GBE interfaces auto-
negotiation is disabled at the
SCE Platform but enabled at
peer
Check auto-
negotiation in SCE
Platform and in
peer
GBE link is up
but Rx LED is
not flashing
GBE interface link LED
is continuous green
GBE interface Rx LED
is not flashing
No traffic is being transmitted
to the SCE Platform from its
peers
Check traffic
connection at peer
GE interfaces auto-negotiation
is disabled at the SCE
Platform but enabled at peer
Check auto-
negotiation in SCE
Platform and in peer
Link LEDs are
continuously
green and Rx
LEDs are
flashing
CLI commands:
show system
operation-
status
show interface
LineCard 0
link-bypass
Verify that in the printout
of this command:
“current bypass state” is
not Cutoff.
System operation-status is
Failure and link-bypass is
configured to be in Cutoff
for Failure state
This is a result of
system failure.
Failure causes are
indicated in the
user log.
Refer to Front Panel
for more information
about the handling of
Failure status.
To recover from this
state you must reload
the SCE Platform.
Page view 258
1 ... 258 259 260 ... 490

Comments to this Manuals

No comments