Cisco SCE 1000 2xGBE User's Guide download pdf (Page 176)

100

101

Chapter 6 Control Configuration

The RDR Formatter

SCE 1000 2xGBE Release 2.0.10 User Guide

6-30 OL-7117-02

EXAMPLE:

The following example shows how to display the current RDR formatter configuration.

SCE 1000#show RDR-formatter

Status: enabled

Connection is: up

Forwarding mode: redundancy

Connection table:

----------------------------------------------------------

Collector | Port | Status | Priority per Category: |

IP Addres / | | |--------------------------|

----------------------------------------------------------

10.1.1.205 |33000 | Up | 100 primary | 100 primary|

10.1.1.206 |33000 | Down | 60 | 60 |

10.12.12.12 |33000 | Up | 40 | 40 |

----------------------------------------------------------

RDR: queued: 0 ,sent: 0, thrown: 0

UM: queued: 0 ,sent: 0, thrown: 0

Logger: queued: 0 ,sent: 0, thrown: 0

Errors: thrown: 0

Last time these counters were cleared: 14:05:57 UTC SUN February 23 2003

SCE 1000#

Refer to CLI Command Reference (on page A-1) for a complete description of the other show

RDR-formatter commands.

Disabling the LineCard from Sending RDRs

The silent command disables the LineCard from issuing Raw Data Records (RDR). Use the

[no] form of this command if you want the LineCard to send reports.

To disable the LineCard from sending Raw Data Records (RDRs):

Step 1 From the SCE 1000(config)# prompt, type interface Linecard 0, and press

Enter.

The SCE 1000(config if)# prompt appears.

Step 2 Type silent, and press Enter.

The LineCard stops producing RDRs and the SCE 1000(config if)# prompt

appears.

To enable the Line Card to produce RDRs:

Step 1 From the SCE 1000(config if)# prompt, type no silent, and press Enter .

The SCE 1000(config if)# prompt appears.

1 ... 175 176 177 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 176

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE