Cisco SCE 1000 2xGBE User's Guide Page 189

  • Download
  • Add to my manuals
  • Print
  • Page
    / 490
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 188
Chapter 6 Control Configuration
Management Interface Configuration Mode
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 6-43
Management Interface Configuration Mode
This interface has a transmission rate of 100 Mbps and is used for management operations and for
transmitting RDRs, which are the output of traffic analysis and management operations. The
parameters that can be configured for this interface include:
IP address of the interface, see Setting the IP Address and Subnet Mask of the FastEthernet
Management Interface.
Speed and duplex, see Configuring the Speed of the FastEthernet Interface (on page 6-43) and
Configuring the Duplex Operation of the FastEthernet Interface (on page 6-43).
Configuring the Management Interface Speed and Duplex Parameters
This section presents sample procedures that describe how to configure the speed and the duplex
of the Management Interface.
Configuring the Duplex Operation of the FastEthernet Interface
To configure the duplex operation of the FastEthernet Management Interface:
Step 1 From the SCE 1000(config if)# prompt, type duplex [auto | full
|half] and press Enter.
Configures the duplex operation of the FastEthernet Management Interface to either half
duplex, or full duplex. auto means auto-negotiation (do not force duplex on the link).
The default of this command is set to auto. Changing this configuration takes effect only
if the speed is not configured to auto.
EXAMPLE:
The following example shows how to use this command to configure the FastEthernet
Management port to half duplex mode.
SCE 1000(config if)#duplex half
Configuring the Speed of the FastEthernet Interface
To configure the speed of the FastEthernet Management Interface:
Step 1 From the SCE 1000(config if)# prompt, type speed speed, where speed can
be 10, 100 (Mbps) or auto and press Enter.
Configures the speed of the FastEthernet Management Interface to either 10 Mbps or 100
Mbps. auto means auto-negotiation (do not force speed on the link).
Page view 188
1 ... 188 189 190 ... 490

Comments to this Manuals

No comments