Cisco SCE 1000 2xGBE User's Guide download pdf (Page 210)

100

101

Chapter 7 Line Configuration

Line Gigabit Ethernet Interfaces

SCE 1000 2xGBE Release 2.0.10 User Guide

7-16 OL-7117-02

Entering GigabitEthernet Line Interface Configuration Mode

To enter GigabitEthernet Interface Configuration Mode:

Step 1 To enter Global Configuration Mode, type configure and press Enter.

The SCE 1000(config)# prompt appears.

Step 2 Type interface GigaBitEthernet [0/1|0/2] and press Enter.

interface GigaBitEthernet 0/1 enables configuration of interface 1

interface GigaBitEthernet 0/2 enables configuration of interface 2

The SCE 1000(config if)# prompt appears.

EXAMPLE:

The following example shows how to enter Configuration Mode for the GigabitEthernet

Interface number 2.

SCE 1000(config)#interface GigabitEthernet 0/2

SCE 1000(config if)#

Configuring GigabitEthernet Auto-Negotiation

Auto-negotiation

By default, the SCE 1000 GigabitEthernet ports are configured with auto-negotiation disabled. In

bump-in-the-wire topologies, auto-negotiation may be enabled, as described below.

The following commands are relevant to auto negotiation:

• [no | default ] autonegotiate

Configuring the GigabitEthernet Auto-negotiation Mode

To configure GigabitEthernet auto-negotiation mode:

Step 1 From the SCE 1000(config if)# prompt, type auto-negotiate, and press Enter.

This configures the GigaBitEthernet to auto-negotiation mode.

Note

Auto-negotiation must be disabled when the SCE 1000is connected to traffic links via an external

optical splitter in external splitting topology.

1 ... 209 210 211 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 210

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE