Appendix A
LineCard Interface Configuration Mode Commands
SCE 1000 2xGBE Release 2.0.10 User Guide
A-38 OL-7117-02
L2TP identify-by
Configures the port number that the LNS and LAC use for L2TP tunnels. The default port number
is 1701.
default 1701
Authorization admin
Mode LineCard Interface Configuration
E
XAMPLE:
The following example identifies the L2TP port as being port# 1000.
SCE 1000(config if)#L2TP identify-by port-number <1000>
connection-mode
Sets the connection mode to either inline (on the wire) or receive-only (using beam splitter or
switch).
Default inline
Authorization admin
Mode LineCard Interface Configuration
P
ARAMETERS
connection-mode inline or receive-only setting.
inline SCE 1000 is connected in a bump-in-the-wire topology.
receive-only SCE 1000 is connected in a out of the line
topology using a beam splitter or switch.
On-failure: determines system behavior on failure of the SCE 1000. (inline topologies
only)
Bypass
cutoff
E
XAMPLE:
The following example sets the connection-mode to inline and the on-failure mode to cutoff.
SCE 1000(config if)# connection-mode inline on-failure cutoff
Comments to this Manuals