Cisco SCE 1000 2xGBE User's Guide Page 191

  • Download
  • Add to my manuals
  • Print
  • Page
    / 490
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 190
Chapter 6 Control Configuration
Entering LineCard Interface Configuration Mode
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 6-45
Configuring Applications
The SCE 1000 platform can be configured to run with different Service Control applications by
installing the appropriate file. All SCE 1000 application files are pqi files, that is, the filename
must end with the pqi extension.
Once a specific Service Control application is installed it can be configured by applying a
configuration file. The configuration file is application-specific, and is produced by application-
specific means, not covered in this documentation. Configuration files have no specific extension.
Note
These configuration changes are automatically saved to the start-up configuration after execution, and
therefore do not appear when the running configuration is displayed (more running-config
command).
These configurations cannot be manipulated by changing the system/config.txt file
Installing an Application
Use the following commands to install, uninstall, and upgrade an application. You can use the
show pqi file command before installing or upgrading an application to display the options
that are available when installing the pqi file. These options can then be specified in the install or
upgrade command as needed.
The documentation of the application will tell the user whether the application is stand-alone (in
which case install should be used), or an upgrade to an existing application that is assumed
to be installed already (in this case upgrade should be used). Currently all Cisco Service
Control applications are stand-alone.
You should always run the pqi unistall command before installing a new pqi file. This prevents
old files from accumulating on the disk.
The following commands are relevant for installing and uninstalling an application:
pqi install file
pqi uninstall file
pqi upgrade file
pqi rollback file
show pqi file
show pqi last-installed
To display information about an application file:
Step 1 From the SCE 1000# prompt, type show pqi file filename info and press
Enter.
Information regarding the pqi file, such as installation options, is displayed and the SCE
1000# prompt appears.
Page view 190
1 ... 190 191 192 ... 490

Comments to this Manuals

No comments