Cisco SCE 1000 2xGBE User's Guide download pdf (Page 120)

Chapter 5 Configuration and Management

Setup Utility

SCE 1000 2xGBE Release 2.0.10 User Guide

5-2 OL-7117-02

Multiple entry parameters (Lists)

Several parameters, such as the Access Control Lists, are actually lists containing a number of

entries. If these lists are empty (initial configuration) or contain only one entry, they act the same

as any scalar parameter, except that you are giving the option of adding additional entries to the

list.

If these lists already contain more than one entry, the entire list is displayed, and you are then

presented with several options. Following is an excerpt from the SNMP trap manager menu,

illustrating how to configure list entries.

To configure a list parameter when more than one entry already exists in the list:

Step 1 The entries in the list are displayed.

There are 2 SNMP trap managers in the current configuration as follows:

IP address: 10.10.10.10 Community: private Version: 1

IP address: 10.11.10.1 Community: pcube Version: 2c

Note

If only one entry exists in the table, it is displayed as the default [ ] to be either accepted or changed The

three list options are not displayed.

Step 2 Three options are presented.

Please choose one of the following options:

1. Leave the running configuration unchanged.

2. Clear the existing lists and configure new ones.

3. Add new entries.

Enter your choice:

Step 3 You are prompted to continue the setup, depending on the choice you entered:

• 1. Leave the running configuration unchanged:

The dialog proceeds to the next question. The list remains unchanged.

• 2. Clear the existing entries and configure new ones:

The dialog prompts you for a new entry in the list.

After completing the first entry, you are asked whether you would like to add another new

entry.

Would you like to add another SNMP trap manager? [no]:y

Since the list was empty, you may enter the maximum number of entries.

• 3. Add new entries:

The dialog prompts you for a new entry in the list.

After the completing one entry, you are asked whether you would like add another new entry.

Would you like to add another SNMP trap manager? [no]:y

You may enter only enough additional entries to reach the maximum number.

1 ... 119 120 121 ... 490

No comments

Cisco SCE 1000 2xGBE User's Guide Page 120