Cisco SCE 1000 2xGBE User's Guide download pdf (Page 355)

100

101

Appendix A

Privileged Exec Mode Commands

SCE 1000 2xGBE Release 2.0.10 User Guide

OL-7117-02 A-85

Parameter Definition

Access Control Lists

Access Control List

number

How many ACLs will be necessary? What IP addresses will be

permitted/denied access for each management interface? You may want

ACLs for the following :

• Any IP access

• Telnet access

• SNMP GET access

• SNMP SET access

list entries (maximum 20

per list)

IP address, and whether permitted or denied access.

IP access ACL ID number of the ACL controlling IP access.

telnet ACL ID number of the ACL controlling telnet access.

SNMP Configuration

SNMP agent status Enable or disable SNMP management.

GET community names Community strings to allow GET access and associated ACLs (maximum

20).

SET community names Community strings to allow SET access and associated ACLs (maximum

20).

trap managers Trap manager IP address, community string, and SNMP version.

(maximum 20)

Authentication Failure

trap status

Set the status of the Authentication Failure trap. (See Traps (on page 6-

34).)

enterprise traps status Set the status of the enterprise traps. (See Traps (on page 6-34).)

system administrator Name of the system administrator.

Topology Configuration

connection mode Is the SCE 1000 installed in bump-in-the-wire topology (inline) or out of

line using a switch with port mirroring (receive-only)?

link bypass mode on

operational status

When the SCE 1000 is operational, should it bypass traffic or not?

Refer, in setup, to the table Setup Command Parameters.

redundant SCE 1000

platform?

Is there a redundant SCE 1000 installed as a backup?

link bypass mode on

non-operational status

When the SCE 1000 is not operational, should it bypass traffic or cut it

off?

Refer, in setup, to the table Setup Command Parameters.

operational status of the

SCE after abnormal boot

After a reboot due to a failure, should the SCE 1000 remain in a Failure

status or move to operational status provided no other problem was

detected?

Refer, in setup, to the table Setup Command Parameters.

1 ... 354 355 356 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 355

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE