Cisco SCE 1000 2xGBE User's Guide download pdf (Page 108)

100

101

Chapter 4 Installation and Startup

Connecting the FE Management Port

SCE 1000 2xGBE Release 2.0.10 User Guide

4-46 OL-7117-02

EXAMPLE #2:

Following is an example of a configuration that was applied and saved to the startup configuration

as well as to an FTP site.

Although not demonstrated in this example, it is recommended that you always view the

configuration before applying it.

Data collection for the system configuration is completed.

Would you like to view the new configuration before it is applied? [yes/no]:

Apply and Save this configuration? [yes/no]: y

(New configuration would be displayed here)

The running configuration would be overwritten by the changes you have just

entered, are you sure? [yes/no]:y

The new running configuration will be saved to the startup configuration.

Do you want to save a copy of the startup configuration file in a remote

station? [no]:y

Enter a full FTP path of the remote destination:

ftp://vk:vk@10.1.1.253/h:/copyofstartup.txt

Committing configuration...

Configuration completed successfully.

Saving configuration...

Writing general configuration file to temporary location...

Backing-up general configuration file...

Copy temporary file to final location...

Done!

EXAMPLE #3:

Following is an example of a configuration that was aborted, although no errors were detected.

Data collection for the system configuration is completed.

Would you like to view the new configuration before it is applied? [yes/no]:

Apply and Save this configuration? [yes/no]: n

The changes you have just entered would be discarded, are you sure?

[yes/no]:y

Setup procedure aborted, no configuration changes made.

Connecting the FE Management Port

This section provides instructions for connecting the FE management port, and executing a check

to verify that connectivity has been established between the SCE 1000 and the remote

management host.

Note

By default, the FE management port is configured to auto-negotiation enabled. To change this default

setting, refer to Configuring FastEthernet Management Interface Speed and Duplex Parameters

1 ... 107 108 109 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 108

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE