Cisco SCE 1000 2xGBE User's Guide Page 197

  • Download
  • Add to my manuals
  • Print
  • Page
    / 490
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 196
Chapter 7 Line Configuration
Configuring Tunneling Protocols
SCE 1000 2xGBE Release 2.0.10 User Guide
OL-7117-02 7-3
Skip MPLS headers.
The MPLS environment is assumed to be Traffic-Engineering.
No IP-tunnel support – L2TP tunnels will not be skipped and therefore all flows within a
single L2TP tunnel will be classified as the same flow.
Selecting the Tunneling Mode
Use these commands to configure tunneling:
ip tunnel
vlan
mpls
L2PT identify-by
Configuring IP Tunnels
By default, IP tunnel recognition is disabled. Use this command to configure recognition of L2TP
tunnels and skipping into the internal IP packet.
An IP tunnel is mutually exclusive with using VLAN for classification.
To configure IP tunnels:
Step 1 From the SCE 1000(config if)# prompt, type:
ip tunnel L2TP skip and press Enter.
To disable identification of IP tunnels:
Step 1 From the SCE 1000(config if)# prompt, type:
no ip tunnel and press Enter.
Configuring the VLAN Environment
Use this command to configure the VLAN environment. There are three options:
symmetric classify
symmetric skip (default)
a-symmetric skip
Page view 196
1 ... 196 197 198 ... 490

Comments to this Manuals

No comments