Cisco SCE 1000 2xGBE User's Guide download pdf (Page 88)

Chapter 4 Installation and Startup

System Configuration

SCE 1000 2xGBE Release 2.0.10 User Guide

4-26 OL-7117-02

System Configuration

Upon initial connection to the local terminal, as described above, the system configuration wizard

automatically runs to guide the user through the entire setup process. The wizard prompts for all

necessary parameters, displaying default values, where applicable. You may accept the default

values or define other values.

With the exception of the time settings, which take effect immediately when entered, the new

configuration is applied and saved only at the end of the dialog when approved by the user.

Therefore, if the setup dialog is aborted, no change takes place in the configuration, other than

time settings (if entered).

When the dialog is complete, you may review the new configuration before applying it. The

system displays the configuration, including parameters that were not changed. The system also

displays any errors that are detected in the configuration. When the configuration is satisfactory,

you may apply and save the new configuration.

The following table lists all the parameter values that are necessary to complete the initial

configuration. It is recommended that you obtain all these values before beginning the setup.

Setup Command Parameters

Table 4-10 Setup Command Parameters

Parameter Definition

IP address IP address of the SCE 1000.

subnet mask Subnet mask of the SCE 1000.

default gateway Default gateway.

hostname Character string used to identify the SCE 1000

admin password Admin level password.

Character string from 4-100 characters beginning with an alpha character.

root password Root level password.

Character string from 4-100 characters beginning with an alpha character.

password encryption

status

Enable or disable password encryption?

Time Settings

time zone name and

offset

Standard time zone abbreviation and minutes offset from UTC.

local time and date Current local time and date. Use the format:

00:00:00 1 January 2002

SNTP Configuration

broadcast client status Set the status of the SNTP broadcast client.

If enabled, the SCE will synchronize its local time with updates received

from SNTP broadcast servers.

1 ... 87 88 89 ... 490

Comments to this Manuals

No comments

Cisco SCE 1000 2xGBE User's Guide Page 88

Comments to this Manuals

Related products and manuals for Networking Cisco SCE 1000 2xGBE